Acesonic AM-888 Manuel d'utilisateur télécharger pdf (Page 14)

3. Hue :Set the Hue of the video +color to increase red

color, -color to increase green color

4.Saturation- Set the degree of the saturation of the video.

1. Downmix: Switch the audio output from LT/RT Mono,

STEREO,VSS and 5.1 CH mode. In LT/RT Mono Mode,

two sound tracks will be mixed and the difference between

these two tracks will be enhance. In VSS mode, two sound

tracks will be mixed and the difference between these two

tracks will be decrease.

Basic Operation-Speaker Setup

2. Sub Woofer You can turn on the sub woofer in 5.1 CH

mode.

3. Center Delay: You can adjust the center speaker delay

according the position of your center speaker.

4. Rear Delay: You can adjust the rear speaker delay

according the position of your speaker.rear

5. Font:

.Change the font to large or samll

Basic Operation-Digital Setup

1. OP MODE: To set the Dolby digital output , you can

switch between Line Out(encode signal) and RF

REMOD(raw signal).

2. Dynamic Range: To set the scale of dynamic range in

Dolby digital logic sound effect.

3. Dual Mono: ,In Dolby sound effect to set the Dual Mono

modes from STEREO, MONO L, MONO R and MIX MONO

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

Pas de commentaire

Acesonic AM-888 Manuel d'utilisateur Page 14