Acesonic AM-888 Manuel d'utilisateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 22
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
Rear Panel Function and Operation
8
5
6
7
8
9
10
11
12
11.BGM IN AUDIO input-
12.PRE-OUT output-
13.AC outlet -
turn
14.REMOTE IN
15.MIC RETURN-
16.MIC SEND-
17.CENTER OUT-
18.REAR MIC INPUT-
19.DVD SENSITIVITY SWITCH-
20.PDP SENSITIVITY SWITCH-
Connect to RCA Audio output jacks of an external component like
background music devices.
Connect to RCA Audio input jacks of an external power amplifier or
Mixing component like Mixer for further signal processing.
Female outlet for alternate current adapter. Total power consumption is
300W.Power is always supplied through these outlets regardless of the POWER switch
setting on the front panel, so the power of the connected components should be ON/OFF
by using their respective power switches.
- Used for connecting with remote control to increase the distance. It
can be connected wired control panel(not included).When it is connected,the
receiver frontpanel would NOT work.
Outputs pure microphone signal to external component.
utputs mixed microphone signal to external component.
Please refer to the “CENTER OUT” section in the supplemental User’s
Guide.
the 3rd/C microphone input and volume adjustment knob.
Sets the sensitivity at which DVD audio input level is
detected and switched automatically.
*L:Set to this position when the input switch does not change to BGM or other mode even if
DVD playback is finished.
*M:Set to this position in normal operating condition.
*H:Set to this position when you want to cange the input switch to other modes even when a
DVD is playing.
Sets the sensitivity at which PDP audio input level is
detected and switched automatically.
*L:Set to this position when the input switch does not change to BGM or other mode even if
the playback from PDP source is finished
*M:Set to this position in normal operating condition.
*H:Set to this position when you want to cange the input switch to other modes even if PDP
source is playing..
signal
be to the
at
O
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

Commentaires sur ces manuels

Pas de commentaire